Make your own Wristlet!

What you need :

1) A smaller version of Jump Rings & a bigger size of Jump Rings. (Around 6 of big ones & alot of small ones depending on your wrist and finger size)


2) Stones, large sized Sequins or /beads. Note should have hole one each side to connect with Jump Rings

4) End Loops of necklaces.

5) Siccor to separate rings.

NOTE : When measuring, have extra small jump rings too(around 2 more) so you can have space to move you hand and bend your hand.



How to start :

1) First get the chain & measure your wrist size with it. Unite small jump rings together depending on your wrist size by opening the jump ring with a siccor to the side & closing after you put a second jump ring into it.

 This is the small jump ring chain i made;

2) Get a big sized jump ring & Put it into one corner of the small jump rings you made. Before closing the opening, get a stone/bead you wish to use, & use the hole on that side to put the stone/bead inside the big jump ring & close the jump ring.

This was my big size jump ring;

& this would be the big jump ring connecting to the bead. I didn't get shot of connecting the big one to the small one though.

3) Get an End Loop and open a current small jump ring of the small jump rings chain you made. Connect the two. In my case i got a different End Loop.

This was the End Loop i got; This didn't need to open the jump rings.

4) Get another big sized jump ring & connect it on the small jump ringed chain we made about three jump rings after. Like this;

Now you're done with the first part. To close this part, just take you're end loop & connect it onto the big jump ring at the middle you did in step 4. This will be the chain that goes around your wrist.



5) Connect another big jump ring onto the stones/beads other side & connect it with another stone into that stone/bead. Make sure you look which side you're putting it. & Connect 1 more big size jump ring to the end of the stone just like we did before.

 If you want you can do this step(optional) Its not a must, i put it because it looked nice and it fit the length of my hand size til i met my middle finger. However a last big jump ring should be at the end. Like this;

6) Now measure your middle finger size-the root (only finger that stays straight to the wrist) & connect small jump rings together to get to that size.

7) Connect one side of the small jump rings to the big jump ring we connected to the stone in step 5.

8) Get an End Loop & connect the end loop's hole into the last small jump ring of what we just did in step 7.

Step 7 & 8 can be seen from this, hope its clear! :/

That's it! Now connect that End Loop into the big jump ring connected to the top stone. This will be the chain that goes around your middle finger.

This is how it looks from the front....

It was really hard to concentrate & explain this. So i'm really sorry if you wouldn't understand properly. But its a really easy things to do just by looking at the pictures. [I did like that too ;) ]
Hope you get it! & if there's any questions (i'm guessing there is? ) Please comment. I'll get back to you soon.(:

These are some other pictures i got from internet. ;) Get some ideas from them too!

Enjoy! xx

Kavi Sam.